Mounting a Scope on a 98 Mauser Receiver

Over the weekend mounted a scope on a 98 Mauser receiver using REDFIELD base and quick release mounts...

Looking at the receiver:


Another look:


A look during the process. At this point he rear hole was drilled all the way through and the front screws were drilled down no deeper then 0.165". This was done to make sure we did not go all the way through on the first screw and also for the far most forward screw which is directly above the chamber to also not go through.



Looking at the finished product:


Another look at it finished:


Thanks
Steven F. Ling